JN0-363 Free Certification Exam Material from PrepAwayExam with 265 Questions [Q74-Q88]

Rate this post

JN0-363 Free Certification Exam Material from PrepAwayExam with 265 Questions

Use Real JN0-363 – 100% Cover Real Exam Questions

The JNCIS-SP Certification Exam is a rigorous exam that requires a significant amount of preparation and study. Candidates must have a thorough understanding of the Junos operating system and the ability to implement it in a service provider environment. JN0-363 exam consists of 65 multiple-choice questions and has a time limit of 90 minutes. A passing score is 65% or higher.

Q74. You must configure an MX Series device to receive and forward a mixture of single-tag and dual-tag frames on interface xe-0/0/0.
In this scenario what will accomplish goal?

xe-0/0/0 {flexible-vlan-tagging;}

xe-0/0/0 {stacked-vlan-tagging;}

xe-0/0/0 {vlan-vci-tagging;}

xe-0/0/0 {vlan-tagging;}

Q75. Click the Exhibit button.

Referring to the exhibit, which statement is correct?

Interface xe-0/0/0.0 has a default metric of 10

Interface ge-3/0/0.0 has a default metric of 10

Interface ge-1/0/0.0 can only form a single adjacency

Interface xe-0/0/0.0 can only form a single adjacency

Q76. You have a stub OSPF area running in your network. Your supervisor has asked you to build a virtual link across this area to connect new equipment acquired in a recent ISP acquisition.Which statement is correct about this scenario?

Type 5 LSAs would be blocked in a stub area.

Type 5 LSAs would carry external information across your transit area to the backbone.

Type 5 LSAs would be seen only in the newly attached area.

Type 5 LSAs would be converted to type 7 LSAs.

Q77. An Ethernet bridge is configured such that all interfaces are in a single broadcast domain.Which two tasks does the bridge perform in response to receiving a frame with an unknown unicast destination MAC address? (Choose two.)

It drops the frame.

It floods the frame out of all interfaces except the one on which is was received.

It learns the destination MAC address.

It learns the source MAC address.

Q78. The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)

The first usable label is 10,001.

The last usable label is 10.501.

The last usable label is 10,499.

The first usable label Is 10,000.

Q79. You want to see a detailed list of all established BGP sessions. In this scenario, what would be a valid command to accomplish this task?

show bgp neighbor

show bgp summary

show rouse receive-protocol bgp <neighbor IP address>

show rouse protocol bgp

Q80. By default, which three criteria are used by the Junos load-balancing algorithm to determine a traffic flow? (Choose three.)

protocol

source port

destination port

source address

destination address

Q81. Which IPv6 extension header notifies intermediary devices that they must inspect the packet’s options?

destination options header

routing header

hop-by-hop options header

fragment header

https://en.wikipedia.org/wiki/IPv6_packet

Q82. You are advertising a summary route that represents your local network (172.20.0.0716) to both ISP A and ISPB. You want to influence all traffic sent to you from ISP C to go through R2.
How would you accomplish this task?

On R1, prepend your AS number three times on the 172.20.0.0/16 route when advertising It to ISP 1.

On R1, change the local preference value to 250.

On R2. prepend your AS number three times on the 172.20.0.0/16 route when advertising it to ISP 2.

On R2, change the local preference value to 50.

Q83. Routers R1 and R4 have a VRRP priority of 90, while R2 and R3 have default VRRP priorities Referring to the exhibit, which router will be elected as the primary VRRP router?

Q84. What are two bridging concepts that are used to maintain an Ethernet switching table? (Choose two.)

learning

exporting

aging

timing

Q85. Click the Exhibit button.

Referring to the exhibit, which statement is correct?

R2 will be the designated router

R3 will not participate in the election process

R1 will not participate in the election process

R4 will be the designated router

https://www.juniper.net/documentation/en_US/junos/topics/topic-map/configuring-ospf-areas.html#id-example-controlling-ospf-designated-router-election

Q86. You are asked to assign interface xe-1/0/5 to a virtual switch. What must be accomplished to complete the configuration?

Interface xe-1/0/5 must be added to routing-instance sw-1 vlan_2.

Interface xe-1/0’5 must be a trunk port.

Interface xe-1/0/5 must be added to routing-instance sw-1.

An IRB interface must be configured to routing-instance sw-1 vlan_2.

Q87. You own a small company and need to assign IPv6 addresses to your routers. Because you want to follow the guidelines spelled out in RFC 3177, you want to design your network with the correct prefixes.Which prefix would your ISP likely allocate to your company?

47-bit prefix

48-bit prefix

64-bit prefix

128-bit prefix

Q88. Click the Exhibit.

You have just configured IS-IS, but the adjacency is not coming up.
Referring to the exhibit, what is the cause?