NEW QUESTION 28
A customer wants you to add a new AFF A700 HA pair to an existing 4-node AFF8080 EX cluster. The existing cluster uses NetApp CN1610 switches for the cluster connection and is using the recommended port count.
Which statement is true in this scenario?

NEW QUESTION 29
You are installing a new AFF A400 cluster that is running ONTAP 9.7 software. You are asked to attach an Amazon S3 cloud tier for FabricPool technology.
In this scenario, which two NetApp License File (NLF) types are supported for cloud tiering? (Choose two.)

NEW QUESTION 30
A customer has an AFF A800 with 24 internal drives and is running out of storage capacity.
In this scenario, which action will solve this issue?

NEW QUESTION 31
You are deploying a cluster with four AFF A300 nodes and Cisco 3232C switches. When you arrive at the customer’s site, you notice that there are multiple breakout cables and four Cisco 3232C switches. In this scenario, which statement is true?

NEW QUESTION 32
You create a new CIFS data LIF with the default failover group.
In this scenario, where will the new LIF failover if the node that owns the new LIF panics?

NEW QUESTION 33
You use the system health subsystem show command to troubleshoot your newly installed ONTAP cluster.
In this scenario, which two health outputs would this command show you? (Choose two.)

NEW QUESTION 34
When planning the installation of a new ONTAP 9.5 cluster for a customer, which three steps should you perform? (Choose three.)

NEW QUESTION 35
Click the Exhibit button.

After you install a FAS2720 with ONTAP 9.5, you disconnect the management port of node A to demonstrate cluster management LIF failover to the custom. When you reconnect the management port and try to revert the interface, you receive the following message.
Info: LIF “cluster_mgmt” has been hosted on port “NetApp-Cluster-01:e0M”, whosehealth status is degraded.
You issue the network port showcommand and see the output shown in the exhibit. When you try to access the cluster interface, you cannot ping or connect to the cluster through the network.
Which two troubleshooting steps must you perform to solve the issue? (Choose two.)

NEW QUESTION 36
Which NetApp tool should you use to set up an ONTAP 9.5 cluster?

NEW QUESTION 37
Your customer wants a newly installed AFF C190 cluster to send SNMP notifications to a trap host called OVERWATCH01.
In this scenario, which two statements are correct? (Choose two.)

NEW QUESTION 38
Click the Exhibit button.

You plan to install a new ONTAP cluster at a customer site by using the new ONTAP System Manager 9.7 GUI.
Referring to the exhibit, what must you do before you provision initial storage?

NEW QUESTION 39
You are creating an aggregate on a new FAS8200 with two DS224C shelves. Your customer wants to be able to use the Disk Maintenance Center.
In this scenario, what is the minimum number of spare disks required per node and disk type?

NEW QUESTION 40
An ONTAP cluster is installed at a secure site. The array has no access to the Internet but is managed 24/7 by onsite engineers. The customer requires that when hardware failures occur, the failures are reported to the NetApp Support team as quickly as possible.
In this scenario, which two tasks should be performed during the project hand-off procedure to satisfy the customer’s requirement? (Choose two.)

NEW QUESTION 41
You are installing a new AFF A400 cluster and need to access the cluster management LIF from a remote subnet with the fully qualified domain name (FQDN) a400.lab.netapp.com.
In this scenario, which two network components must be configured to log in to ONTAP System Manager from the remote subnet? (Choose two.)

NEW QUESTION 42
In an ONTAP switched cluster, which three types of traffic travels over the cluster network? (Choose three.)

NEW QUESTION 43
You are preparing for a new installation. While determining the most suitable version of ONTAP software to deploy, you want to verify the ONTAP 9 release cadence to ensure that you are deploying a Long Term Service (LTS) release.
In this scenario, where would you find this information?

NEW QUESTION 44
After completing the installation of an AFF A800 ONTAP AI cluster, you are asked which contacts are available for additional help in obtaining immediate assistance in solving P1 issues.
In this scenario, what do you tell the customer?