QUESTION 58
Your customer is having connectivity issues with a newly-deployed Microbranch group The access points in this group are online in Aruba Central, but no VPN tunnels are forming.
What is the most likely cause of this issue?

QUESTION 59
Match the terms below to their characteristics (Options may be used more than once or not at all.)

QUESTION 60
Match the terms below to their characteristics (Options may be used more than once or not at all.)

QUESTION 61
How do you allow a new VLAN 100 between VSX pair inter-switch-link 256 for port 1/45 and 2/45?

QUESTION 62
A customer is concerned about me unprotected traffic between an AOS-CX switch and a gateway, running on AOStO. What is a feasible option to protect this traffic?

QUESTION 63
Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements After the configuration was complete, it was noted that a user assigned with the administrators role did not have the appropriate level of access on the switch.
The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role Which default management role should have been assigned for the user?

QUESTION 64
Refer to the exhibit.

With Core-1. what is the default value for config-revision?

QUESTION 65
Your customer has asked you to assign a switch management role for a new user The customer requires the user role to only have Web Ul access to the System > Log page and only have access to the GET method for REST API for the /logs/event resource Which default AOS-CX user role meets these requirements?

QUESTION 66
With Aruba CX 6300. how do you configure ip address 10 10 10 1 for the interface in default state for interface 1/1/1?

QUESTION 67
A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working to a remote site connected via layer-3 All legacy devices are connected to a dedicated Aruba CX 6200 switch at each site.
What technology on the Aruba CX 6200 could be used to meet this requirement?

QUESTION 68
How is Dynamic Multicast Optimization (DMO) implemented in an HPE Aruba wireless network?

QUESTION 69
A client is connecting to 802.1X SSID that has been configured in tunnel mode with the default AP-group settings.
After receiving Access-Accept from the RADIUS server, the Aruba Gateway will send Access-Accept to the AP through which tunnel?

QUESTION 70
A client is connecting to 802.1X SSID that has been configured in tunnel mode with the default AP-group settings.
After receiving Access-Accept from the RADIUS server, the Aruba Gateway will send Access-Accept to the AP through which tunnel?

QUESTION 71
Which statement best describes QoS?

QUESTION 72
Your customer has four (4) Aruba 7200 Series Gateways and two (2) 7000 Series Gateways. The customer wants to form a cluster with these Gateways. What design consideration would prevent you from using all of those Gateways?

QUESTION 73
A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcamers to clients.
Which technology is the best match for this use case?

QUESTION 74
You are configuring an SVI on an Aruba CX switch that needs to have the following characteristics:
* VLANID = 25
. IPv4 address 10 105 43 1 with mask 255 255 255.0
* IPv6 address fd00:5708::f02d:4df6 with a 64 bit prefix length
* member of VRF eng
* VRF eng and VLAN 25 have not yet been created
Which command lists will satisfy the requirements with the least number of commands?

QUESTION 75
You are deploying a bonded 40 MHz wide channel What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

QUESTION 76
What is a primary benefit of BSS coloring?