NO.42 You are deploying IP phones in your Layer 2 network and are asked to ensure that the switch sends VLAN and CoS information to the IP phones automatically.
In this scenario, which protocol should be used?

NO.43 Exhibit:

Your IS-IS adjacency is not established as shown in the exhibit. What is the problem?

NO.44 Click the Exhibit button.

Referring to the exhibit, you must advertise the 100.0.0.0/16 routes from AS1 to AS2, but R2 is not advertising any BGP routes to R5.
Why is this happening in this scenario?

NO.45 Exhibit:

Referring to the exhibit, on which three IS-IS routers will the attached bit be set? (Choose three. )

NO.46 Exhibit.

You are authenticating user devices connected to your ex Series switch. You have802.1X and MAC RADIUS configured for all ports A user is complaining about the time it takes to connect their non-802.1X device on ge-0/0/15 using MAC RADIUS authentication Referring to the exhibit, what should be done to accelerate the authentication process?

NO.47 You are deploying IP phones in your Layer 2 network and are asked to ensure that the switch sends VLAN and CoS information to the IP phones automatically.
In this scenario, which protocol should be used?

NO.48 Exhibit:

You are troubleshooting a route problem in the topology shown in the exhibit. The 10.30.0 0/24 route is not reachable from the R3 router. What would cause this problem?

NO.49 Exhibit.


Referring to the exhibit, there are multiple ASM groups in the 224 0 0.0/4 range Which configuration change is needed to ensure R1 is always the RP for group 224.224.1.1?

NO.50 Click the Exhibit button.

You are adding VNI 101 to your EVPN-VXLAN network, but traffic is not being sent or received.
Referring to the exhibit, which configuration statement will solve the problem?

NO.51 In IS-IS advertising POUs with the overload bit has which effect?

NO.52 Exhibit.

Referring to the exhibit, a RMSM network is set up to enable communication between multicast devices.
Which statement is true in this scenario?

NO.53 Exhibit.

You are adding VNI 101 to your EVPN-VXLAN network, but traffic is not being sent to received.
Referring to the exhibit, which configuration statement will solve the problem?

NO.54 What are two supported PoE management modes? (Choose two.)

NO.55 When redistributing IGP routes into BGP. what information .s used by default on Junos platforms to determine the BGP route’s MED attribute value?

NO.56 Exhibit.

Referring to the exhibit, which two statements are true regarding Q-in-Q tunneling? {Choose two)

NO.57 Click the Exhibit button.

You have configured and applied the policer shown in the exhibit to your Junos device.
Which statement is true in this scenario?

NO.58 Exhibit:

Which two statements are true about the 802. 1X output shown in the exhibit? (Choose two.)