NO.25 You want to view the VLANs that have been created dynamically using MVRP. Which operational mode command will display this information?

NO.26 Click the Exhibit button.

Which well-known community needs to be used to restrict 10.0.0.0/8 from being advertised to AS
2?

NO.27 You are asked to configure an 802.1X solution that supports dynamic VLAN assignment. In this scenario, which two modes support using vendor-specific attributes (VSAs)? (Choose two.)

NO.28 Referring to the exhibit, which LSA type is used to advertise 192.168.1.0/24 to R5?

NO.29 When configuring connectivity to a VoIP enabled phone, which two statements are correct?
(Choose two.)

NO.30 Which three configuration parameters must match on all switches within the same MSTP region?
(Choose three.)

NO.31 You must ensure that all routes in the 10.0.0/8 address range are not advertised outside of your AS.
Which well-known BGP community should be assigned to these addresses to accomplish this task?

NO.32 What are two similarities between OSPFv2 and OSPFv3? (Choose two.)

NO.33 You have an MX960 configured as a Fusion aggregation device (AD) and two QFX5100 switches as satellite devices (SD). You have configured local-switching for each SD. A packet with an unknown MAC address is received on one of the SD extended ports.
Which statement is correct in this scenario?

NO.34 You are asked to configure 802.1X on your access ports to allow only a single device to authenticate. In this scenario, which configuration would you use?

NO.35 Which two statements are correct regarding the behavior shown in the exhibit? (Choose two.)

NO.36 You are troubleshooting an EVPN-VXLAN IP fabric and observe the loop shown in the exhibit.
Which two steps would you take to further troubleshoot this problem? (Choose two.)

NO.37 Which statement is correct about IS-IS?

NO.38 You are configuring BGP policies for a site with a dual-homed connection as shown In the exhibit.
You need all outbound traffic to egress the network through the link to ISP B by default. The ISPs should not be able to override this behavior through BGP attributes.
Which BGP attribute would you modify on the ISP-received routes to accomplish this objective?

NO.39 You are implementing a single spanning tree instance in your network and want to use the protocol that will give you the best convergence time in the event of a physical network failure of the root bridge. Which spanning tree protocol will satisfy this requirement?

NO.40 You are designing a multicast topology to support IPv4 IPTV broadcasts in your organization. The design should support multiple multicast senders with overlapping group addresses while preventing interference between them. Client devices currently do not support IGMPv3.
Which approach would fulfill these requirements?

NO.41 You are asked to deploy 802.1X on your EX Series switches. You need to ensure authenticated devices continue to have access to the network even if the authentication server fails.
Which action meets this configuration objective?

NO.42 You are redistributing static routes into an OSPF area. Which two statement are true is this scenario? (Choose two.)

NO.43 You are asked to establish interface level authentication for users connecting to your network. You must ensure that only corporate devices, identified by MAC addresses, are allowed to connect and authenticate. Authentication must be handled by a centralized server to increase scalability.
Which authentication method would satisfy this requirement?

NO.44 Click the Exhibit.

The Receiver is attempting to join two different groups, one from each source. You want to endure that load balancing is taking place.
Referring to the exhibit, which statement is true?

NO.45 You are implementing the route summarization feature of OSPF. Which two results do you achieve in this scenario? (Choose two.)